Applies to models such as HT801, HT802, HT812, HT814, HT818
Step 1: Log In to the Web Interface
Connect a PC to the same network as the ATA device.
Find the IP address of the ATA (pick up the handset connected to FXS port and dial
***
→ then dial02
to hear IP).Open a browser and go to:
http://[DEVICE_IP]
Log in (default credentials:
Username:
admin
Password: admin
Step 2: Navigate to FXS Port Settings
Go to the "FXS Port" tab (e.g., FXS Port 1, FXS Port 2, etc.).
Configure the following:
SIP Settings
Field | Value |
---|---|
Primary SIP Server | |
SIP User ID | YOUR_USER_ID |
Authenticate ID | YOUR_USER_ID |
Authenticate Password | YOUR_PASSWORD |
Name | Fax |
SIP Registration | Yes |
Outgoing Call Without Reg | No |
Unregister on Reboot | Yes |
Register Expiration | 3 |
Enable SIP OPTIONS Keep Alive | Yes |
Use Random SIP Port | Yes |
Use Random RTP Port | Yes |
Call Waiting / Tone Handling
Feature | Setting |
---|---|
Disable Call-Waiting | Yes |
Disable Call-Waiting Caller ID | Yes |
Disable Call-Waiting Tone | Yes |
Use First Matching Vocoder in 200OK SDP | Yes |
Audio Codec Preferences
Set the Preferred Vocoder list (in order):
PCMA
PCMU
PCMA
PCMA
PCMA
PCMA
PCMA
Field | Value |
---|---|
iLBC Frame Size | 20ms |
VAD | No |
Symmetric RTP | No |
Fax Settings
Setting | Value |
---|---|
Fax Mode | T.38 |
Re-INVITE After Fax Tone Detected | Enabled |
Buffer & Echo Settings
Field | Value |
---|---|
Jitter Buffer Type | Adaptive |
Jitter Buffer Length | High |
SLIC Setting | AUSTRALIA |
Gain | TX 0dB, RX -12dB |
Disable Line Echo Canceller | Yes |
Disable Network Echo Suppressor | Yes |
Step 3: Configure Regional Tones
Go to Advanced Settings tab
Scroll to Custom Ring Tone & Dial Tone Settings
Insert the following tone strings into respective fields:
Tone Type | Value |
---|---|
Dial Tone | f1=425@-11,f2=0@-11,c=0/0; |
Ringback Tone | f1=440@-17,f2=480@-17,c=2000/4000; |
Busy Tone | f1=425@-11,f2=0@-11,c=37/37; |
Reorder Tone | f1=425@-11,f2=0@-11,c=37/37; |
Confirmation Tone | f1=350@-11,f2=440@-11,c=100/100-100/100-100/100; |
Call Waiting Tone | f1=440@-13,c=300/10000; |
Prompt Tone | f1=350@-17,f2=440@-17,c=0/0; |
Step 4: Save & Apply Settings
Scroll to the bottom of the configuration page.
Click Update or Apply.
When prompted, reboot the ATA to apply settings.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article